In all cases, the TV will switch to SmartCast Home if there is no signal on the previously used port, and won't switch if there is a signal. I went back and tested everything with CEC enabled and disabled, and there was no difference. I hope this helps someone else out there.Įdit: I forgot to add that Vizio tech support's official solution to this problem is to disable HDMI-CEC on the Vizio display. I added a five-second delay between the AVR and TV startup steps to make sure I never end up on the wrong side of a race condition, but it's not strictly necessary. The solution was to put the AVR first in the startup sequence. I hope you get this message as soon as you can so it helps. Step 4 go to Screen Saver then step 5 click on Screen Saver to turn it off. Even though the Denon AVR starts up one second after the display and the display is still in the process of booting, it is still long enough for the TV to decide that there is no signal on HDMI-1 and switch to Smartcast. Hi I own this kind of tv and it works wonderful here are the steps on how to turn off your screen saver. In my case, I made the mistake of setting my startup sequence to start the Vizio TV before my Denon AVR. This behavior also seems to be happening when the TV is booting up. An alert will appear telling you that it's about to change your input. You can see this behavior if you set to an empty HDMI port and wait about ten seconds. I use a Logitech Harmony smart remote, which is supposed to set the input to HDMI 1 whenever I turn everything on, but it wasn't doing that.Īfter hours and hours of experimentation, I discovered that the new firmware update is configured to change the input to the Smartcast home screen whenever no signal is detected on the current HDMI input. After a recent firmware upgrade, I noticed that my P75-C1 suddenly started bringing up the Smartcast home screen whenever I turned the television on.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |